Advertisement
Set up Instructions of SUP
1. Valve operation
The inflation valve is located nearby the nose of the board.
Screw out the lid with valve wrench, then the center valve pin is
appeared. It can close/open the valve by pressing it once and
again.
2. To inflate the board, please refer to images to follow the below
steps
A).Unscrew the valve cap and press down on the pin to open the
valve. Let the air flow naturally into the product, then press down
on the pin again to close the valve (in the UP position).
B).Make sure the pump hose is connected to the 'inflate' outlet.
C).Attach the pump hose clockwise onto the valve.
D).Start pumping air into the board by sliding the piston up and
down till the board is fully inflated.
E).After inflation, screw the valve cap and tighten it with valve
wrench.
3. To deflate the board, screw out the valve lid, press the valve pin
to let it is in the open position.please be careful of any sand or
debris around the valve area when deflating as the small
particles could become airborne together with the release of the
air pressure.
-4 -
Advertisement
