Vertical Steam Burst; Cleaning Your Iron - Maytag SMARTFILL M1400 Quick Start Manual

VERTICAL STEAM BURST

A
B
C
12
FOR VERTICAL STEAM BURST
Vertical Steam Burst allows you to remove wrinkles from
hanging clothes, curtains, and other hanging fabrics.
1. Hang the garment up to be steamed.
2. Turn the Steam Control & Self-Clean Dial to high
(image A).
3. Plug the iron into an outlet while on its heel.
4. Turn on the iron and set the Temperature Control
Button to the appropriate setting for your fabric.
5. Preheat takes about 60 seconds.
6. Hold the iron upright and close to the fabric, but
never touching. This works best about six inches
away (image B).
7. Push the Steam Burst Button (image C)
directing the steam at the area of the fabric you wish
to steam. Repeat for tough wrinkles.
8. When finished ironing, turn off your Iron by pressing
the Temperature Control Button for three seconds,
then unplug. Remember to move the Steam Control
& Self-Clean Dial back to the "Off" position.

CLEANING YOUR IRON

PLEASE READ FIRST
We recommend cleaning your iron once per month to remove impurities that may build up inside
the Ceramic Soleplate over the use of your iron. When the soleplate needs to be cleaned, the
Cleaning Icon
The self-cleaning function does produce hot steam and water during the process; hold iron away
from your body as water/steam exit the Ceramic Soleplate during cleaning.
1. Ensure iron is unplugged.
2. Fill the Removable Water Tank halfway with water following "Filling Removable Water Tank"
and close Water Fill Cover.
3. Place iron in an upright position. Place Steam Control
& Self-Clean Dial in the "Off" position.
4. Turn on iron and set the temperature to MAX.
Heat to MAX, then turn the iron off and unplug.
5. Hold the iron over the sink with the Ceramic
Soleplate facing down.
while
6. Set the Steam Control & Self-Clean Dial to Self-Clean.
Hot water and steam will come out of the Soleplate.
7. Continue to hold the Steam Control & Self-Clean Dial down until all the water has emptied
from the Removable Water Tank. You may have to move the iron back and forth to remove
most of the water from the Removable Water Tank.
8. When water/steam stops flowing, release the Steam Control & Self-Clean Dial and stand the
iron up on its heel to cool down.
9. Once the iron is cool, wipe down the Ceramic Soleplate with a cold damp cloth.
10. When ready to use again, plug the iron in and let heat for about 2 minutes to dry out any
remaining water.
Caution: Keep skin and body away from hot water and steam as it is released from the iron.
on the Digital Interface will illuminate.
13