Table of Contents
Advertisement
en Troubleshooting
Fault
The drying time is too
long.
"AIr" and the appli-
ance is not respond-
ing to operation.
46
Cause and troubleshooting
Regularly dry a load weighing more than 3 kg of
▶
damp laundry until the programme ends.
Insufficient condensation for the automatic self-clean-
ing when permanently using the crease-removal func-
tion.
Regularly dry a load weighing more than 3 kg of
▶
damp laundry until the programme ends.
The appliance's ventilation opening is blocked.
Ensure that the ventilation opening of the appliance
▶
is kept clear.
Heat exchanger is soiled.
→ "Running the basic appliance care programme
▶
on the appliance", Page 35
The base unit filter is damp.
→ "Cleaning the filter system on the base unit",
1.
Page 28.
Dry the filter thoroughly after cleaning.
2.
→ "Closing the base unit", Page 40.
3.
→ "Switching off the appliance", Page 28.
4.
→ "Switching on the appliance", Page 27.
5.
→ "Starting the programme", Page 28.
6.
"Ready in" time is activated and the ambient temperat-
ure is lower than 16 °C.
Ensure that the ambient temperature is above 16
▶
°C or start the next drying process within 2 hours.
→ " Technical data", Page 52
Remote start is activated and the ambient temperature
is lower than 16 °C.
Ensure that the ambient temperature is above 16
▶
°C or start the next drying process within 2 hours.
→ " Technical data", Page 52
The ambient temperature is low and the base unit fil-
ter is damp.
→ "Cleaning the filter system on the base unit",
1.
Page 28.
Dry the filter thoroughly after cleaning.
2.
→ "Closing the base unit", Page 40.
3.
→ "Switching off the appliance", Page 28.
4.
→ "Switching on the appliance", Page 27.
5.
→ "Starting the programme", Page 28.
6.
Advertisement
Table of Contents
