Assembly Instructions - Craftsman WEEDWACKER INCREDI-PULL 316.791700 Operator's Manual

ADJUSTING THE D-HANDLE
1. Loosen the bolt on the D-
handle just enough to move
it (Fig. 1).
2. While holding the unit in the
operating position (Fig. 12),
move the D-handle to the
location that provides the
best grip.
3. Tighten the bolt until the D-
handle is secure (Fig. 1).
OPERATING THE CONVERTIBLE™ COUPLER SYSTEM
WARNING:
Before beginning the use of any attachment, read
and understand the manual that came with the attachment. Follow
all safety information contained within.
WARNING:
These attachments are to be snapped into the
primary hole only. Using the wrong hole could lead to personal
injury or damage to the unit.
The Convertible™ coupler system enables the use of these optional
attachments. For information about attachments, call 1-800-4-MY-HOME®.
• Edger
• Cultivator
• Turbo Blower
• Brushcutter
• Pole Saw
• Hedge Trimmer
INSTALLING THE TRIMMER ATTACHMENT OR OTHER ATTACHMENT
WARNING:
Before operating this unit, be sure that the release
button is fully snapped into the primary hole (Fig. 2), and that the
knob (Fig. 4) is securely tightened.
NOTE: To make installing or
removing the attachment
easier, place the unit on
the ground or on a work
bench.
1. Turn knob counterclockwise
to loosen (Fig. 4).
2. While firmly holding the
trimmer attachment or other
attachment, push it straight
into the Convertible™
coupler until the release
button snaps firmly into the
primary hole (Fig. 3).
NOTE: Aligning the release
button with the guide
recess will help
installation (Fig. 2).
3. Turn the knob clockwise to
tighten (Fig. 4).
NOTE: When using the line
trimmer or other
attachment to edge, lock
the attachment release
button into the 90° hole
(Fig. 4).

ASSEMBLY INSTRUCTIONS

Shaft Grip
D-Handle
Min. 6 in.
(15.24 cm)
Bolt
Fig. 1
Convertible™ Release Button
Coupler
Guide Recess
Fig. 2
Primary Hole
Upper Shaft
Attachment
Shaft
Fig. 3
REMOVING THE TRIMMER ATTACHMENT OR OTHER ATTACHMENT
WARNING:
To avoid serious personal injury and damage to the
unit, shut the unit off before removing or installing attachment.
1. Turn the knob
counterclockwise to loosen
(Fig. 4).
2. Press and hold the release
button (Fig. 2).
3. While firmly holding the
upper shaft, pull the trimmer
attachment or other
attachment straight out of
the Convertible™ coupler
(Fig. 3).
5
90˚ Edging Hole
(Trimmer Only)
Knob
Fig. 4