Warranty; Know Your Unit; Assembly Instructions - Craftsman WEEDWACKER INCREDI-PULL 316.791201 Operator's Manual

FOR 2 YEARS from the date of purchase, this product is warranted against any defects in material or workmanship. Defective product will receive free repair or
free replacement if repair is unavailable.
For warranty coverage details to obtain repair or replacement, visit the web site: www.craftsman.com
This warranty covers ONLY defects in material and workmanship. Warranty coverage does NOT include:
• Expendable items that can wear out from normal use within the warranty period, such as cutting line, filters or spark plugs.
• Product damage resulting from user attempts at product modification or repair or caused by product accessories.
• Repairs necessary because of accident or failure to operate or maintain the product according to all supplied instructions.
• Preventive maintenance, or repairs necessary due to improper fuel mixture, contaminated or stale fuel.
This warranty is void if this product is ever used while providing commercial services or if rented to another person.
This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
APPLICATIONS
As a trimmer:
• Cutting grass and light weeds
• Edging
• Decorative trimming around trees, fences, etc.
Other optional accessories may be used with this unit.
Hassle Free ®
Cutting Head
ADJUSTING THE D-HANDLE
1. Loosen the bolt on the
handle just enough to move
it (Fig. 1).
2. While holding the unit in the
operating position (Fig. 11),
move the D-handle to the
location that provides the
best grip.
3. Tighten the bolt until the D-
handle is secure (Fig. 1).
WARRANTY STATEMENT
CRAFTSMAN 2 YEAR FULL WARRANTY
Sears Brands Management Corporation, Hoffman Estates, IL 60179
Shaft Housing
Cutting Head Shield

ASSEMBLY INSTRUCTIONS

Shaft Grip
Shaft Housing
Minimum 6 in.
(15.24 cm)
Bolt
Fig. 1

KNOW YOUR UNIT

Shaft Grip
On/Off
Control
D-Handle
Convertible™
Coupler
INSTALL CUTTING
ATTACHMENT SHIELD
Use the following instructions if
the cutting attachment shield on
the unit is not installed.
1. Place the cutting head shield
onto the guard mount
bracket, making sure to align
the holes on the shield with
D-Handle
the ones in the guard mount
bracket. (Fig. 2)
2. Take the 2 shield screws and
screw each one into the
shield until finger tight.
3. Using an appropriate screw driver, tighten the screws until the shield is
firmly in place. Make sure the screws are tightened equally so there is a
balanced gap between the bracket and the shield on each side.
4
Spark Plug
Fuel Cap
Throttle
Control
Primer Bulb
Cutting
Head Shield
Fig. 2
Starter Rope
Grip
Air Filter
Cover
(2) Screws
Guard
Mount
Bracket