Advertisement
6. Select static RGB color
Press
and
key to select color from the preset
library colors.
7. Shortcut color select
Shortcut key to static colors. LED will run the
relevant color when pressing the specific color key. The
shortcut color is included in 'COLOR+' and 'COLOR-'
content.
8. White brightness control
Press
key to increase white LED brightness and
press
key to decrease.
9. RGB brightness control
Press
key to increase RGB LED brightness and press
key to decrease.
10. RGB dynamic effect
These keys control the RGB dynamic effects. Press
and
to select dynamic effects and press
EFFECT
key to set the running speed of the dynamic effects.
11. Remote indicator
This indicator blinks when remote controller is working.
If the indicator flash slowly when pressing keys, it means the
remote battery is nearly empty and please change the
battery in this case. The battery model is CR2032.
Overheat Protection
The controller has overheat protection feature and it can
protect itself from damage caused by some abnormal usage
such as overloading which generates excess heat. At
overheat situation, the controller will shutdown the output for
a short while and recover when temperature drops to a safe
range.
Please check the output current and make sure it's under
rated level at this situation.
Specification
Output mode
Working voltage
Rated output current
Static color
Dynamic effect
White brightness grade
Color brightness grade
Speed grade
Direct color select
PWM frequency
PWM physical grade
Overheat protection
Remote frequency
Remote control distance
Power off memorizing
Controller dimension
and
PWM constant voltage
DC 5-24V
4x2A (Total max 6A)
30 colors
42 modes
10 levels
5 levels
10 levels
7 direct keys
1KHz
4000 steps
Yes
433.92MHz
>15m at open area
Yes, restore to previous mode before off.
50x15x7mm
Remote operation
12. Using the remote controller
Please pull out the battery insulate tape before using.
The RF wireless remote signal can pass through some
nonmetal barrier. For proper receiving remote signal, please
do not install the controller in closed metal parts.
13. Pair a new remote controller
The remote controller and receiver is 1 to 1 paired as
factory default. It's possible to pair maximum 5 remote
controllers to one receiver and each remote controller could
be paired to any receivers.
To pair a new remote controller, please follow two steps:
1). Plug off the power of main unit and plug in again after
more than 5 seconds.
2). Press
seconds, within 10 seconds after the receiver powered on.
After this operation, the LED fixture will flash quickly to
EFFECT
acknowledge that remote pairing is accomplished.
14. Keep one remote and forget others
In some cases, one receiver might be paired with several
remote controllers but extra remote controllers are no
longer needed except current using one. User can simply
pair the current using remote to receiver again, then the
receiver will dis-pair all other remote controllers and
recognize current one only.
4
6
and
keys simultaneously for about 3
5
Advertisement
