Operation - Briggs & Stratton BWS018 Operator's Manual

4. Turn OFF water and release trigger. Point gun in a safe direction
and make sure trigger cannot be squeezed.
5. Connect standard spray tip or turbo tip to wand
simply insert the tip (O) into the wand (P) in correct direction
and push further till it's locked. Keep pressing the red release
button and pull the tip out to release.
O
6. Connect patio cleaner
Insert and twist patio cleaner tip (Q) into the extension (K) and
follow the instruction stated in 2.
Make sure the patio cleaner extension and the spray gun are
connected properly and securely locked to ensure there is no
twisting of arm, body, gun and the patio cleaner during

operation.

7. Connect the foam lance
NOTICE Foam lance and detergent bottle can only be used with
adjustable fan jet lance and standard spray tip, not the turbo tip.
Slide the foam lance (S) onto the adjustable fan jet lance (R)
or the standard spray tip (T). Apply further inward pressure to
wand until you hear a CLICK and the locking tab (U) falls into
place over the lip (V) of the wand. Tug on foam lance to make
sure it is securely in place. When release lift up the lock tab
to unlock and pull the foam lance away.
V
R
P
J
K
Q
S
U
S
Checklist Before Starting Pump Motor
Review the unit's assembly to ensure you have performed all of
the following.
1. Be sure to read Safety Rules and Operation before using the
electric pressure washer.
2. Check to make sure the connections of water inlet and outlet
are correct and properly tightened.
3. Check to make sure there are no kinks, cuts, or damage to
hoses.
WARNING High pressure hoses, fittings and couplings are
important for the safety of the appliance.
Use only hoses, fittings and couplings recommended by the
manufacturer.
4. Provide a proper water supply at an adequate flow (not to exceed
38°C).
5. Plug electrical cord into a properly grounded electrical source.
NOTICE Model BWS018,BWS020 and BWD023B are double
insulated, BWD020S is not double insulated therefore requires
properly grounded electrical supply.
Servicing Of A Double-Insulated Appliance
In a double-insulated product, two systems of insulation are
provided instead of grounding. No grounding means is provided
on a double-insulated product, nor should a means for grounding
be added to the product. Servicing a double-insulated product
requires extreme care and knowledge of the system, and should be
done only by qualified service personnel. Replacement parts for a
double-insulated product must be identical to the parts they replace.
A double-insulated product is marked with the words "DOUBLE
INSULATION" or "DOUBLE INSULATED."
The symbol means DOUBLE-INSULATED APPLIANCE.
V
U
T
13