Table of Contents
Advertisement
Operation
ON
OFF
Loading and ejecting a disc
Remember - AC adapter must be connected.
Loading a disc
1. Push the Eject Button to open the Top cover.
2. Load a disc. (Label facing up.)
Push down on the center of the disc until the
disc clicks into place. Otherwise the disc may
spin off the spindle and be damaged.
Please do not press too hard. Also, be careful
not to touch the lens on the pick-up mechanism.
3. Close the top cover.
Notes
When loading a disc, press the disc's inner edge against the side of the spring-
loaded spindle bumper inside the disc compartment. Make sure that the disc is not
sitting on top of the bumper before closing the top cover.
Ejecting a disc
Power must be applied to the drive.
1. Push the eject button to open the top cover.
The top cover will open slightly.
Carefully open the lid to the straight-up position.
2. Removing the disc. Hold one finger against the
edge of the disc from the side of the drive,
and press another finger against the spindle in
the center of the drive to remove the disc.
3. Close the top cover after removing the disc.
Notes
Make sure the disc has stopped turning before trying to eject the disc.
Don't open the top cover when the power busy indicator blinks. Opening the cover
while the power busy indicator blinks will stop any operation with the computer.
8
ON
ON
OF
OF
F
F
ON
ON
F
F
OF
OF
Hide quick links:
Advertisement
Table of Contents
