Table of Contents
Advertisement
TROUBLESHOOTING
Problems with Wi-Fi signal
Possible cause
New router installed or router configuration
changed.
The wireless network signal is weak.
The wireless signal is disrupted by a micro‐
wave appliance placed near the oven.
12.2 How to manage: Error codes
When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
F240, F439 - the touch fields on the display do not
work properly.
F601 - there is a problem with Wi-Fi signal.
F604 - the first connection to Wi-Fi failed.
F908 - the oven system cannot connect with the
control panel.
In this section, you will find the list of the problems that have to be handled by a qualified
technician.
Code and description
F131 - the temperature of magnetron sensor is too
high.
36/48
Remedy
To configure oven and mobile device again, re‐
fer to "Before first use" chapter, Wireless con‐
nection.
Move router as close to the oven as possible.
Turn off the microwave appliance.
Action
Clean the surface of the display. Make
sure there is no dirt on the touch fields.
Check your network connection. Refer to
"Before first use" chapter, Wireless con‐
nection.
Turn the oven off and on and try again.
Refer to "Before first use" chapter, Wire‐
less connection.
Turn the oven off and on.
Action
Turn the oven off and wait until it cools
down. Turn the oven on again.
Advertisement
Table of Contents
