Antenna - LG DU-27FB32C Installation And Operating Manual, Warranty

Hook Up an Off Air Antenna
Connect an over the air signal source to the TV
Over the Air Antenna
Locate the Antenna/Cable
1
jack on the back of the TV.
Connect the antenna that
2
runs from the wall directly to
this jack, according to the
connection diagram shown
to the right.
If you have a 75 ohm RF
cable, then you don't need
any adapters!
A 300 to 75 ohm adapter is
not included with the LG TV.
To get digital with only one RF antenna lead, install a signal splitter
1
If there is only one antenna lead
available from the wall antenna
jack, locate the Antenna/Cable
and the Digital Antenna jacks on
the back of the TV.
2 Connect the antenna that runs
from the wall directly to a 75
ohm 2-way signal splitter (not
provided) according to the con-
nection diagram shown to the
right.
3
Connect the two antenna leads
to the TV RF inputs:
Antenna/Cable and Digital
Antenna. This will provide the
same over the air signal to both
the analog and digital RF inputs.
Mini Glossary
2-Way Splitter A device that provides two antenna signals from one antenna lead.
75 ohm The wire that comes from an off-air antenna or cable service provider. Each end
RF Cable looks like a hex shaped nut with a wire sticking through the middle, and it screws
onto the threaded jack on the back of the TV.
300 to (Not shown) A small device that connects a flat two-wire 300 ohm antenna to a 75
75 ohm ohm RF jack. They are usually about an inch long with two screws on one end and a
Adapter round opening with a wire sticking out on the other end.
Page 12

Antenna

Antenna
Antenna Cable
RF Coaxial Wire
(75 ohm)
M.P.I.
RF Coaxial Wire
(75ohm)
Antenna
RF Coaxial Wire
Antenna
(75 ohm)
Cable
M.P.I.
75 ohm
Signal Splitter
Typ ical
TV Bac k
Digital
Pr Pb
Antenna R Audio L
Y
Video In
R Audio In L
M.P.I.
Typ ical
TV Bac k
Digital
Pr Pb
Antenna R Audio L
Y
Video In
R Audio In L
M.P.I.