LG DU-27FB32C Installation And Operating Manual, Warranty page 51

LT2000 QuickSet Programmer
Cloning Preparations
Before You Begin Cloning...
• Only use one MPI port for connecting
to MPI equipment.
• Do not run Auto Program while TV is
connected to clone programmer.
• The "master TV" should be connected
to a good, stable signal from an over-
the-air antenna or cable service and
turned on.
• Teaching and Learning is only possi-
ble between identical model LG TVs.
(However, the Clone programmer can
store 3 different master TV setups.)
WARNING: Copying a blank or incorrect
memory into a TV will cause
the TV to operate erratically or
become inoperable.
• Use an LG MBR Remote like the
MBR3447LG or the TV front panel con-
trols to operate Learning and Teaching
menus.
• Make sure that the batteries in the
Clone programmer are fresh.
• If the batteries are removed, the
Clone Clock time will be lost.
• Decide if you want to set the time
from the Clone programmer or copy the
time to the Clone programmer; from a
TV which has the clock set to the cur-
rent time.
A slow flashing green light indicates there is a problem with the communica-
tions between the TV and the programmer. In this case, check for a damaged
cable, poor contacts or other connection troubles.
If the status indicator is red, the programmer batteries are low and should
be replaced. Use 4 good-quality alkaline AA batteries.
• Follow the connection diagrams on
the previous page to connect the Clone
to a master TV and, after learning is
complete, to another TV to "teach" it
the setup.
• Setting the time and transferring it
to the Clone or another TV is a separate
procedure.
• Once a TV's setup is copied to anoth-
er TV, that TV needs to be disconnected
from power for about 5 seconds to acti-
vate the newly copied setup.
• See Troubleshooting to solve prob-
lems.
A. Set Up a Master TV
Using an LG Multi-Brand remote like
the MBR3447LG, set up a "Master" TV
with custom settings and features as
described in the TV's operating guide.
The master TV's Setup is what you will
copy to the Clone Programmer and
transfer to TVs with the same model
number so they will operate identically.
B. Connect Clone to Master TV
If there is a good connection, the
"Clone has Control of TV" message will
appear. (See menu on the previous
page.)
Page 51