Safety Information - Haier Cube 90 Series User Manual

1. Safety information

1. Safety information
Read the following safety hints before switching on the appliance for the first time:
WARNING!
Before first use
Make sure there has been no damage during transportation.
Remove all packaging and keep it out of the reach of children.
Wait at least two hours before installing the appliance in order to ensure that
the refrigerant circuit is fully efficient.
Always ensure that at least two people handle the appliance, because it is heavy.
Installation
The appliance should be placed in a well-ventilated place. Ensure a space of
at least 10 cm above and 10 cm around the appliance.
Never place the appliance in a damp area or location where it might be splashed
with water. Clean up stains and splashes of water and dry with a clean, soft cloth.
Do not install the appliance in direct sunlight or near heat sources (e.g.
stoves, heaters).
Install and level the appliance in an area suitable for its size and use.
Keep ventilation openings in the appliance or in the in-built structure clear of
obstruction.
Make sure that the electrical information on the rating plate is compatible
with the power supply. If it is not, contact an electrician.
The appliance runs on a 220-240 VAC/50 Hz power supply. Abnormal voltage
fluctuation may cause the appliance to fail to start, or damage the temperature
control or compressor, or there may be abnormal noise when operating. In such
case, an automatic regulator shall be mounted.
Use a separate earthed socket which is easily accessible for the power
supply. The appliance must be earthed.
UK only: The appliance's power cable is fitted with 3-cord (grounding)
plug that fits a standard 3-cord (grounded) socket. Never cut off or
dismount the third pin (grounding). The plug should be accessible after
the appliance is installed.
Do not use multi-plug adapters and extension cables.
Ensure that the power cable is not trapped by the refrigerator. Do not step
on the power cable.
Do not damage the refrigerant circuit.
3
EN