Panasonic Quasar PVQ-1310 Service Manual page 58

7.3.4. STEREO/SAP SEPARATION ADJUSTMENT (MODEL: L)
Purpose:
To separate the L and R Channels of Stereo Signal.
Symptom of Misadjustment:
The L and R Channels of Stereo Signal will not be separated
properly resulting in no stereophonic effect.
Test Point:
TP9001 (Audio C.B.A.)
Adjustment:
R9001, R9008 (Audio C.B.A.)
Specification:
minimum level
INPUT:
Antenna Input Terminal
MTS (ONLY L CH)
300 Hz±5 Hz, 3 kHz±5 Hz
14 % or 7 % Modulating
Mode:
STEREO audio (TV)
Equipment:
Oscilloscope, MTS/SAP Signal Generator
1. Set to TV mode, and then set to STEREO audio.
2. Connect the RF OUTPUT of the MTS/SAP Signal Generator to the
Antenna Input Terminal.
Then, set the MTS/SAP Signal Generator as follows.
MTS (ONLY L CH)
300 Hz±5 Hz
14 % or 7 % Modulating
3. Connect the Oscilloscope to TP9001 on the Audio C.B.A.
4. Adjust R9001 (SEP (L) ) on the Audio C.B.A. so that the signal level
of TP9001 is minimum.
5. Set the MTS/SAP Signal Generator as follows.
MTS (ONLY L CH)
58