Panasonic Quasar PVQ-1310 Service Manual page 27

3. Installation of VCR Chassis Unit
When installing 2 Screws (S-7), slide the Holder Unit of the
Cassette Up Ass'y (Refer to
UNLOADING OF
screws. Then, slide it back to the EJECT Position.
Make sure that Mechanism and Cassette Up Ass'y are in the
EJECT Position. (Refer to
DISASSEMBLY/ASSEMBLY PROCEDURES.)
4. Removal of TV/VCR Main C. B. A.
Work carefully so as not to break Sensor LED when lifting the
Mechanism Chassis and Cassette Up Ass'y.
Installation of Mechanism Chassis and Cassette Up Ass'y onto TV/
VCR Main C.B.A.
A. Make sure the Mode Select SW. on the TV/VCR Main C.B.A. is in
EJECT position. If not, rotate the Mode Select SW. until the
alignment projection is in the EJECT Position.
B. Make sure the Mechanism and Cassette Up Ass'y are in the
EJECT Position. (Refer to
DISASSEMBLY/ASSEMBLY PROCEDURES.)
C. Install the Mechanism Chassis and Cassette Up Ass'y straight
onto the TV/VCR Main C.B.A. so that the Sensor LED clears the
"METHOD FOR LOADING/
MECHANISM" in SERVICE NOTES) to tighten
"EJECT Position
"EJECT Position
Fig. D8
27
Confirmation" in
Confirmation" in