Related Manuals for Yardworks 400 Series
Summary of Contents for Yardworks 400 Series
- Page 1 21" Rear Dis charge Push Mower 400 Se ries IM POR TANT: READ SAFETY RULES AND IN STRUC TIONS CARE FULLY BE FORE OP ER AT ING EQUIP MENT. YARDWORKS, TO RONTO, ON TARIO M5B 2B8 PRINTED IN U.S.A. OG-705A...
-
Page 2: Table Of Contents
XXXXXXXXXXX XXXXXXXXXX XX-XXXX-X Copy the se rial num ber here: YARDWORKS TORONTO, ONT. M4S 2B8 1-866-523-5218 EN GINE IN FOR MA TION The en gine man u fac turer is re spon si ble for all en gine-re lated is sues with re gards to per for mance, power-rat ing, spec i fi ca tions, war ranty and ser vice. -
Page 3: Im Por Tant Safe Op Er A Tion Prac Tices
IM POR TANT SAFE OP ER A TION PRAC TICES WARNING: This symbol points out important safety in structions which, if not fol lowed, could en danger the per sonal safety and/or prop erty of yourself and others. Read and fol low all in structions in this man - ual be fore at tempting to op erate this ma chine. - Page 4 Extinguish all cig arettes, ci gars, pipes and other sources of ig ni- Slope Operation • tion. Slopes are a ma jor factor re lated to slip and fall ac cidents Never fuel ma chine in doors be cause flammable va pors will ac - •...
-
Page 5: Slope Gauge
SLOPE GAUGE (Keep this sheet in a safe place for future ref erence.) Use this page as a guide to de termine slopes where you may not op erate safely. Do not operate your lawn mower on such slopes. -
Page 6: Set-Up In Struc Tions
SET-UP Carriage Bolt Lower This unit is shipped WITH OUT GAS O LINE or OIL. Handle Af ter as sem bly, ser vice en gine with gas o line and oil as in structed in the sep a rate en gine man ual packed with your unit. - Page 7 Cable Tie Hook Lower Handle Hole in Plastic Channel Fig ure 5 the starter rope into the rope guide bolt on han - Plastic dle. Channels Attaching Rear Wheels (If Not Al ready At tached) Fig ure 7 Re move the hex flanged nut on the rear axle and •...
-
Page 8: Operation
Hinged Mulching Plug (optional) Blade Con trol Han dle Side Chute Deflector (optional) Starter Hinge Pin Handle Fig ure 11 Fig ure 9 Grasp the re coil starter han dle as shown and pull • slowly un til re sis tance is felt, then pull rap idly to start Slide the two hooks on the side dis charge de flec tor •... -
Page 9: Adjustments
to ward the wheel, mov ing up or down to se lected Do not cut wet grass. For ef fec tive mulch ing do not cut • wet grass be cause it tends to stick to the un der side of height. -
Page 10: Off Sea Son Stor Age In Struc Tions
ance by bal anc ing it on a round shaft screw driver. Blade Adapter Re move metal from the heavy side un til it bal ances evenly. Blade Be fore re as sem bling the blade and the blade adapter to the unit, lu bri cate the en gine crank shaft and the in ner Blade Bell sur face of the blade adapter with light oil. -
Page 11: Trou Ble Shooting
TROU BLE SHOOTING PROB LEM POS SI BLE CAUSE(S) COR REC TIVE AC TION Engine fails to start 1. Blade con trol han dle dis en gaged. 1. Engage blade con trol han dle. 2. Spark plug wire dis connected. 2. -
Page 12: Re Place Ment Parts/Pièces Détachées
For mod els with 8" rear wheels/ Pour modèles à roue arrière de 8 po Refer to page 14 for mod els with 12" rear wheels./ Référez-vous à la page 14 pour modèles à roues arrière de 12 po. - Page 13 PART N° DE N° DE RÉF PIÈCE DE SCRIP TION DE SCRIP TION 747-1161A Blade Con trol Han dle - Black Poignée de commande de la lame-noir 749-1092A Up per Han dle -Black Guidon supérieur-noir 747-04080 Catcher Lower Frame Sac à herbe - bâti inférieur 749-0928B Lower Han dle Guidon inférieur...
- Page 14 For mod els with 12" rear wheels/ Pour modèles à roue arrière de 12 po PART N° DE N° DE RÉF PIÈCE DE SCRIP TION DE SCRIP TION 787-01231 21" Deck Ass’y (Mod els with side Corps 21 po (modèles avec éjection latérale dis charge only) seulement) 787-01208...
-
Page 15: War Ranty
Additional Limited Sixty Days War ranty on Bat tery: Af ter one hun dred eighty (180) days but within two hun dred forty (240) days from the date of pur chase, YARDWORKS CAN ADA will re place the de fective bat tery, for the orig i- nal pur chaser, for a cost of one-half (1/2) of the cur rent re tail price of the bat tery in ef fect at the date of re turn. - Page 16 Model/Modèle Shroud/Capot Hard ware/Quincaillerie 11A-083F515 7511682114 11A-413F516 7511682114 11A-413F800 7511682114 11A-435R515 7511682114 12A-283F515 7511682114 11A-416A563 751B699869 710-1256 12AD466A563 751B699869 710-1256 11A-418B552 751B699864 751BB095050 11A-439R565 751B281440 710-1256 11A-108N565 751B281440 710-1256 11A-418N500 751B281440 710-1256 11A-588B552 751B281440 710-1256 11B-439B552 751B281440 710-1256 12A-558O552 751B281440 710-1256 12AD569R565 751B281440...
- Page 17 notes . . .