Advertisement
ASSEMBLY
•
Assemble the stand by inserting the outer tube into the base, fit the weight and
secure in place using the locking screw. Place the assembly upright.
•
Secure the fan motor to the upper tube using the screws provided.
•
Remove the guard fixing screws from the motor and attach the rear guard to the
fan motor, securing it in place with the screws.
•
Slide the fan blade onto the shaft and fix into place with the locking screw on the
centre boss.
•
Remove the bolt and nut from the bottom of the front guard and rotate all clips to
an open position.
•
Attach the front fan guard, lining up the top notch with the rear guard and ensuring
the bolt hole is aligned for the two halves.
•
Close the clips and replace the nut and bolt locking the two halves together.
OPERATION
•
Connect the power plug to a suitable outlet.
•
Select the desired speed using the speed control:
0 = Off
1 = Low speed
2 = Medium speed
3 = High speed
•
The incline of the ventilator head can be adjusted by tilting it forwards or
backwards. The ventilator head can then be locked into position, which is indicated
by an audible click.
•
To adjust the height, slacken the height adjustment screw, slide the upper section
to the required height and re-tighten the adjustment screw.
CLEANING & STORAGE
•
Before cleaning, turn the fan off and unplug from the power supply.
•
Use a soft cloth to wipe off any dust. If the fan is very dirty, use a damp cloth and
wipe dry.
•
Do not use any chemicals, abrasives or solvents that could damage the fan.
•
Store the fan in its original packaging in a dry ventilated area.
•
The motor bearings are permanently sealed and do not require additional
lubrication.
TECHNICAL SPECIFICATION
Power consumption
Main voltage
Dimensions
Weight
50W
220-240V~ 50Hz
400 x 400 x 1250mm
6.3kg
Advertisement
