LG DLE3400 Series Manual page 20

20 OPERATION_DLE3500* / DLG3501* / DLE3460* / DLG3461* / DLEX3*00* / DLGX3*01*
Rack Dry (On Some Models)
Use the Rack Dry function with items, such as
wool swearters, silk items, and lingerie, that should
be dried flat. Rack Dry can also be used with items
that should not be tumbled dry, such as gym shoes
or stuffed animals.
NOTE
• NEVER tumble dry a load of clothing with
the rack installed.
• When the rack is installed, the drum
will rotate as usual, but the rack will not
move. Make sure all articles to be dried
remain completely on the rack and cannot
fall off or be pulled off by the turning
drum. Be sure to remove the rack after
use.
Using the Rack Dry Cycle
1
With the dryer door open, slide the rack into
the dryer drum.
2
Make sure it is seated evenly on the edge
of the inner door rim and resting flat on the
inside of the dryer.
3
Place wet items on the rack. Allow space
around the items for air to circulate.
4
Close the door and select Rack Dry.
5
Press Temp. to select a temperature option.
If no temperature is selected, Rack Dry
defaults to no heat.
Special Functions
Some cycle option buttons also activate secondary
functions. These special functions are marked with
an asterisk (*). Press and hold the option button
marked with the special function to activate it.
Control Lock
Use this option to prevent unwanted use of the
dryer or to keep cycle settings from being changed
while the dryer is operating.
Activating the Control Lock Function
Press and hold the Wrinkle Care button for 3 seconds.
The Control Lock icon will be shown in the display, and
all controls will be disabled except the Power button.
Deactivating the Control Lock Function
Press and hold the Wrinkle Care button for 3 seconds.
Once set, Control Lock remains active until it is
manually deactivated. Control Lock must be turned
off to run another cycle.
Custom PGM
Save special combinations of settings that are
used frequently as a custom program.
Saving a Custom Program
1
Turn on the dryer and select the desired
settings using the cycle selector knob and
cycle modifier or option buttons.
2
Press and hold the Custom PGM button for
three seconds.
NOTE
• Only one custom program can be saved at a time.
Pressing and holding the Custom PGM button will
overwrite any previously saved custom program.
Recalling a Custom Program
1
Turn on the dryer and press the Custom PGM button.
2
Press the Start/Pause button to start the cycle.
Default On/Off
This option allows the Energy Saver settings to
be changed. To run a Normal cycle without the
Energy Saver option, press and hold the Energy
Saver button for three seconds. ON or OFF
appears in the display.