About the front and rear wheel speed sensor
Do not remove the speed sensors installed at
the front and rear wheels because they are
used for regulating YRC controls.
•
If you change the front and rear wheels
to non-standard parts, manufacture and
attach a rotor and sensor referring to the
diagram below.
•
If you change the front fork/rear brake
bracket to a non-standard part too, create
a mount for the sensor assembly and
attach the front and rear wheel sensors
referring to the diagram below.
*1. When manufacturing a rotor and sensor,
use a steel type material with magnetic
properties.
*2. Make the angle of attachment in the
rotation direction of the rotor of the sensor
assembly the same as the angle indicated
in the diagram below.
*3. If you change the rotor sensor or sensor
assembly attachment bracket to a non-
standard part, there is a possibility of
malfunction due to vibration or noise even
if the part is attached properly.
– 17 –