Getting To Know Your Orchestras; Getting Started; Unpacking Orchestra - Sonoro ORCHESTRA Operating Manual

2. GETTING TO KNOW YOUR ORCHESTRAS

Front and side view
1
2

3. GETTING STARTED

3.1 UNPACKING ORCHESTRA

1. Take the ORCHESTRAS out of the packaging and check whether the
ORCHESTRAS or the individual parts exhibit damages. If this is the case,
do not use the ORCHESTRAS. Should you detect any damage, contact your
dealer or sonoro audio GmbH customer support immediately.
2. Check to make sure that the delivery is complete (2 speakers, 2 speaker meshes,
2 bass plugs).
3. Place the ORCHESTRAS at a suitable and safe location. If you want to put your
ORCHESTRAS on a natural wood surface, please make sure that it is suitable.
On oiled and waxed surfaces, stains may occur.
4. Do not touch or push the woofer and tweeter on the front of ORCHESTRA.
This can destroy the speaker.
ORCHESTRAS can be connected to amplifer as show
below. To avoid short circuits, please first switch
off the amplifier to which you want to connect your
ORCHESTRAS. Connect the right speaker to the right
and left speaker to the left channel of your amplifier.
Be careful not to reverse the polarity of + and –.
8
Rear and back view
3
When connecting the speaker cable,
take notice of the followings:
• Do not let the bare wires of the speaker cable
touch one another.
• Do not let the bare wires of the speaker cable
come into contact with ORCHESTRA's rear
panel and screws.
1. AMT tweeter
2. Woofer
4
3. Speaker mesh
4. Bass port
5. Connectors (– +)
5
SPEAKER IMPEDANCE 4 16
© sonoro audio GmbH 2022