ProCurve J8455A Quick Start Manual

Quick Start Guide
ProCurve Secure Router dl 1xE1 + G.703 Module
J8455A
S
PECIFICATIONS
Operating E1/FE1 Frame Relay, E1/FE1 PPP
Modes
E1/FE1 Line Rate: 2.048 Mbps ±50 PPM
Interface Line Code: AMI or HDB3
Framing: FAS with optional CRC-4
FE1 Line Rate: Channelized timeslot (in multiples of
56/64 kbps)
Receiver Sensitivity: -30 dB
Connector: RJ-48C
G.703 Interface Line Interface: Per ITU-T G.703
Line Rate: 2.048 Mbps, ±50 PPM
Line Code: AMI or HDB3
Framing: FAS with Optional CRC-4
Receiver Sensitivity: -30 dB
Capacity: 1 to 31 timeslots
If timeslot 16 signaling is used on the drop port, a maximum
of 15 timeslots can be mapped to router
(1 to 15 or 17 to 31).
Connector: RJ-48C
Clock Source Network, internal, and through
Diagnostics Test Pattern Generation and Detection: QRSS, 511,
all ones, all zeros
Network loopbacks
Alarm generation and detection
Network performance data (15 minutes and 24 hours)
Standards FCC Part 15 Class A, EN 55022 Class, EN 55024,
EN 61000-3-2, EN 61000-3-3
ACIF S016, ETSI TBR 12/TBR 13
EN60950, AS/NZS 60950
ITU G.603, ITU-T G.704 (CRC-4), ITU-T G.823,
ITU-T G.797
Physical Dimensions: 6.99 cm (2.75 in) W x 10.80 cm (4.25 in) D
Operating Temperature: 0°C to 50°C (32°F to 122°F)
Relative Humidity: Up to 95 percent, noncondensing
at 30°C (86°F)
Non-Operating Temperature: -20°C to 70°C (-4°F to 158°F)
Non-Operating Relative Humidity: Up to 95 percent,
noncondensing at 30°C (86°F)
Altitude: Up to 3.05 km (10,000 ft)
61195878L1-13B, April 2005
5990-8895
I I
NSTALLATION NSTRUCTIONS
1. Remove power from the unit.
2. Slide the interface module into the option slot until the interface module
is firmly seated against the chassis.
3. Secure the screws at both edges of the interface module.
4. Connect the cables to the associated device(s).
5. Complete the installation of the base unit.
6. Restore power to the unit.
Note
For safety information for the routers and all modules,
please refer to the safety and ESD precautions in the
ProCurve Secure Router Installation Guide included
in your router shipment.
E1 N (RJ-48C) C
ETWORK
Pin Name
1 R1
2 T1
3 —
4 R
5 T
6-8 —
G.703 (RJ-48C) C
Pin Name
1 R
2 T
3 —
4 R1
5 T1
6-8 —
www.procurve.com
P
ONNECTION INOUT
Description
Receive data from the network
Receive data from the network
Unused
Transmit data toward the network
Transmit data toward the network
Unused
P
ONNECTION INOUT
Description
Transmit data toward the DTE
Transmit data toward the DTE
Unused
Receive data from the DTE
Receive data from the DTE
Unused
Copyright 2005 Hewlett-Packard Development Company, LP