Table of Contents
Advertisement
2. To place the ventilator on the support, follow the sequence
below:
a.
Pull the handle bracket on the wall, just above the
fixed support;
b.
Slide Oxymag down until it clicks into place;
Below is provided the sequence to assemble the support on the
bench:
1.
Install the fixed support with +12V DC power (3803835) on
the bench using 2 screws (3003446) item 2 of the figure to
the side.
Figure 10: Installation of the fixed support on the bench
23
Figure 9: Connection of the ventilator to the fixed support
Figure 11: Connection of the ventilator to the support
c.
Press the safety lock of the ventilator turning the two
eccentric buttons from the top until the red dots are
invisible;
d.
Make sure that Oxymag is fixed in placed;
e.
To remove Oxymag, perform the reverse procedure.
2. To place the ventilator on the support, follow the sequence
below:
a.
Insert the handle holder in the support above the fixed
support;
b.
Slide Oxymag down until it clicks into place;
c.
Activate the safety lock of the ventilator turning both
eccentric buttons from the top until the red dots are
invisible;
d.
Make sure that Oxymag is fixed in place;
e.
To remove Oxymag, perform the reverse procedure.
Manual Oxymag_Rev22
Advertisement
Table of Contents
