Skyfan DC SKY903WH Instruction Manual page 9

• The SkyfanDC Remote control comes pre-paired at the factory and is ready to use. REMOTE CONTROL OPERATION
Pairing will only be required in situations mentioned below.
• A remote control consists of two parts.
• A remote control consists of two parts .
1. Handset (transmitter) controller.
2. Receiver. Receives messages from the handset and is located in upper canopy
1. Handset (transmitter) controller.
of the fan.
• The Skyfan DC remote control comes pre-paired at the factory and is ready
to use.
Pairing will only be required in situations mentioned below.
1. Using 1 remote handset to control 2 or more Skyfan DC Ceiling fans
• Choose the fan you wish to pair with your handset.
• Turn isolation switch 'ON' and within 20 seconds press and hold
remote for 3 seconds. The fan will emit a 'beep beep' sound to indicate
the pairing process is activated.
• Press and change the speed of the ceiling fan via the remote to check the
operation and successful pairing.
2. Loss of function or control between hand piece and receiver
• Try the re-pairing process as outlined above (point 1). If the problem persists,
call Ventair technical support on 1300 665 926.
3. Replacing an old or damaged handset
• If you are replacing a handset only (not the receiver), the repairing process
(point 1) will need to be performed before operation of the fan is possible.
REMOTE CONTROL OPERATION
Handset
9
9
Reciever
on the