Dimplex VFE 20 Installation And Operating Instructions Manual page 44

English
P11 – Supplementary heating Yes/No
NOTE
The supplementary heating is available as an acces-
sory and is not installed at the factory.
Enter whether operation is to take place with or with-
out supplementary heating.
Call up the installer menu.

Confirm the PIN code four times with the ENTER

key. Display P9 flashes.
Use the keys to select P11. Display flashes.

Press the ENTER key. ON flashes.

Operation with supplementary heating:

Press the ENTER key. Setting is complete.
Operation without supplementary heating:
Use the keys to select OFF. OFF flashes.
Press the ENTER key. Setting is complete.
P12 – Release signal
Function for future charge release directly on the stor-
age heater. Currently without function.
NOTE
This menu item may be shown or not shown depend-
ing on the version. Do not change the setting values!
EN-16
P13 – Release manual
NOTE
Only required if there is a continuous voltage on the
terminals L1, L2, L3 and no release takes place by the
energy supplier or grid operator.
Call up the installer menu.

Confirm the PIN code four times with the ENTER

key. Display P9 flashes.
Use the keys to select P13. Display flashes.

Press the ENTER key. A1 flashes.

Press the ENTER key. The hours display flashes.

Use the keys to set the hour for the start of

the release.
NOTE
When entering the release times, always start with the
lowest hour, e.g. 00:00.
Example:
The release times 22:00 to 06:00 and 14:00 to 16:00
should be set.
Set A1 ON to 00:00 and A1 OFF to 06:00.

Set A2 ON to 14:00 and A2 OFF to 16:00.

Set A3 ON to 22:00 and A3 OFF to 23:59.

A4 ON and A4 OFF remain on 23:59.

2202/D
Commissioning
www.dimplex.eu