Table of Contents
Advertisement
Installation
en
Sliding out the appliance
Before you remove the appliance, protect the hob
Note:
with a piece of polystyrene from the packaging.
Use a flat-blade screwdriver to push in the fastening
1.
bolt, and turn it 90° until it locks into place.
Push in the fastening bolt gently with your fingers,
2.
and turn it until it comes out of the housing along
with the spring.
©
Pull gently on the fastening bolt; before you do this,
take hold of the appliance from beneath with the
other hand.
ª
Carefully remove the appliance.
3.
14
Screw in the filler strip fully.
4.
¨
Push in the fastening bolt and turn it 90°.
5.
Note:
the appliance must be able to move.
Final fitting stage
Slide the appliance up into place.
1.
Lock the fastening bolts on the left and right.
2.
Fit the protective caps on the left and right.
3.
Establish the electrical connection.
4.
The fastening pieces on the left and right of
¨
©
ª
Advertisement
Table of Contents
