Bosch Professional GWS 11-125 Original Instructions Manual page 31

Speed preselection
(GWS 12-125 CIE / GWS 13-125 CIE / GWS 15-125 CIE /
GWS 15-125 CIT / GWS 15-125 Inox / GWS 17-125 CIE /
GWS 17-125 CIT / GWS 17-125 Inox / GWS 19-125 CIE)
You can select the required speed using the speed preselec-
tion thumbwheel (4), even during operation. The informa-
tion in the table below describes the recommended values.
Material Application
Metal Removing paint
Metal Brushing, removing rust
Stainless steel Grinding
Metal Rough grinding
Metal Cutting
Stone Cutting
The rated speed of the accessory must be at least
u
equal to the maximum speed marked on the power
Level GWS 12-125 CIE
Speed preselec- GWS 13-125 CIE
tion GWS 15-125 CIE
GWS 17-125 CIE
GWS 19-125 CIE
-1
[min ]
1 2800
2 4500
3 6300
4 8200
5 9800
6 11,500
The values specified for speed levels are guide values.
Fitting
Fitting Protective Equipment
Pull the plug out of the socket before carrying out any
u
work on the power tool.
Note: If the grinding disc breaks during operation or the
holding fixtures on the protective guard/power tool become
damaged, the power tool must be sent to the after-sales ser-
vice immediately; see the "After-Sales Service and Applica-
tion Service" section for addresses.
Bosch Power Tools
Application tool
Sanding sheet
Cup brush, abrasive disc
Grinding disc/fibre disc
Grinding disc
Cutting disc
Diamond cutting disc
tool. Accessories running faster than their rated speed
can break and fly apart.
GWS 15-125 Inox
GWS 17-125 Inox
-1
[min ]
2200
3300
4400
5400
6500
7500
Protective guard for grinding
Adjust the position of the protective guard (8) to meet the
requirements of the operation. To do this, push the unlock-
ing lever (1) upward and rotate the protective guard (8) into
the required position.
English | 31
Thumbwheel position
2–3
3
4–6
6
6
6
GWS 17-125 CIT
-1
[min ]
2800
4100
5400
6700
8000
9300
Place the protective guard
(8) onto the holder on the
power tool until the coding
cams of the protective guard
are aligned with the holder.
When doing so, press and
hold the unlocking lever (1).
Press the protective guard
(8) onto the spindle collar un-
til the shoulder of the pro-
tective guard is sitting on the
flange of the power tool and
rotate the protective guard
until it audibly clicks into
place.
1 609 92A 5RE | (16.02.2022)