Bosch Intuvia 100 Owner's Manual page 8

English – 6
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following mea-
sures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
– Consult the dealer or an experienced radio/TV tech-
nician for help.
Radiofrequency radiation exposure Information:
The radiated output power of the device is far below
the FCC radio frequency exposure limits. Neverthe-
less, the device shall be used in such a manner that
the potential for human contact during normal opera-
tion is minimized.
This equipment complies with FCC radiation expo-
sure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum distance of 20 cm between the radiator and
your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or
transmitter.
ISED Notice (Canada)
This device contains licence-exempt transmitter(s)/
receiver(s) that comply with Innovation, Science and
Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two con-
ditions:
1. this device may not cause interference, and
2. this device must accept any interference, including
interference that may cause undesired operation
of the device.
This equipment complies with Canada radiation expo-
sure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum distance of 20 cm between the radiator and
your body. This transmitter must not be co-located or
0 275 U07 3BI | (08.06.2022)
operating in conjunction with any other antenna or
transmitter.
Certification information: You can find FCC- and IC-ID
on the display under <Settings> → <Certifica-
tions>.
Privacy notice
If the on-board computer is sent to Bosch Service be-
cause it requires servicing, the data stored on the on-
board computer may be transmitted to Bosch.
Bosch eBike Systems