Advertisement
Quick Links
MINI JUMPER
WARNING:
Not suitable for children under 3 years old. Contains small parts and long cord.
Adult assembly required. Always use under adult supervision.
Maximum Weight: 35kg/77Ibs
CUSTOMER SERVICE
Toll Free: 1-800-333-061
MONDAY-FRIDAY, 9 A.M-5 P.M CENTRAL TIME
Advertisement
Related Manuals for KMART MINI JUMPER
Summary of Contents for KMART MINI JUMPER
- Page 1 MINI JUMPER WARNING: Not suitable for children under 3 years old. Contains small parts and long cord. Adult assembly required. Always use under adult supervision. Maximum Weight: 35kg/77Ibs CUSTOMER SERVICE Toll Free: 1-800-333-061 MONDAY-FRIDAY, 9 A.M-5 P.M CENTRAL TIME...
- Page 2 Not suitable for children under 3 years old due to small parts and long cords. WARNING: Avoid eye injury,DO NOT overstretch. ALWAYS keep face and body out of recoil path. DO NOT use when strap has visible signs of wear of damage. CHOKING HAZARD: Contains small assembly components with functional sharp points and edges.
- Page 3 Front Side base frame Left handle bar Right handle bar M6 X33MM SCREW M6 X36MM SCREW Wrench Allen key...
- Page 4 NOTE: 1. DO NOT OVER-THIGHTEN THE NUTS AND BOLTS AT EVERY STEP. 2. DO NOT SNAP IN THE COVER OF PLASTIC CAP UNTIL YOU HAVE FINISHED THE ASSEMBLY OF EACH STEP AND GO BACK TIGHTEN ALL OF THE NUTS AND BOLTS. Step in chart #1.
- Page 5 Step 3. Attach back base frame ② to side base frame 1B, secure with screws, washers & nuts as shown in chart #3. Repeat same manner to other side of base frame 1B. Do not over-tighten the screws/nuts at this step. chart #3 chart #4 Step4.
- Page 6 Put one of tube leg into the circle of bungee cord and fixed the cord on the leg, Step 5 As shown in chart #5. chart #5...
- Page 7 Step 6: Position Jump Mat in central of square frame, make sure the two padded corner with velcor toward the side of frame with handle, as shown in chart #6. chart #6 Step 7: Turn over the pad skirt on the mat, as shown in chart #7. chart #7...
- Page 8 NOTE: Wear the gloves before assembling this step. Step 8: Thread the bungee cord through the black webbing over all the frame, as shown in chart #8. chart #8...
- Page 9 Step 9: After the bungee cord is threaded completely, grasp the two end of bungee cords and connect both ends together with clamp clip and cover with PVC tube, as shown in chart #9 and chart #10. Step 10: Adjust the bungee cord all the way, and make sure there has similar distance between the mat and the frame on all sides.
- Page 10 Step 11: If you have found the frame is a little bit curved, you need to hold up one angle to have one leg touch the ground as shown in chart #11, to press it until you adjust the frame in the square shape. chart #11 Note: go back to re-check all screws and nuts and tighten all now.
- Page 11 Step 13: Tie elastic band around the leg to other two corners as shown in chart #13. chart #13 Always place the trampoline on a level surface before assembly and use. If this trampoline is used indoor, place the product on a slip-resistant and level surface indoors, such as on carpet or on a large rubber mat. Do not place the trampoline on smooth or slippery surfaces such as a concrete or tiled floor.