Vixen Horns VXA7223 Installation Manual

BEFORE BEGINNING YOUR INSTALLATION
Read through the instruction guide before getting started with the installation. Professional installation is recommended for
this product.
CONTENTS


18 PSI Compact Air Compressor

 Mounting Hardware
The specific voltage requirement for this compressor is 12 volt DC, therefore installation must be done to a DC
power source of 12 volts.

SAFETY INSTRUCTIONS

 Make sure you never attempt to disassemble this horn kit's electrical components.
 Never use your bare hands to any part of the compressor immediately after or during use.
 Avoid operating this product in an area with risk of falling or submergence into a liquid (water).
 Do not reach out for or touch any component that has fallen or been submerged into water.
 Make sure you set up in areas with good ventilation.
 Make sure your battery ground is detached before getting your installation started.

Employ equipment for eye protection during drilling operations.

COMPRESSOR MOUNTING

 The ideal location for the compressor to be installed is a dry area inside your engine compartment where it
will be safe from exhaust and engine manifold heat.
 To make the compressor firm and secure, drill a hole of 3/16". IMPORTANT: The compressor must be
mounted vertically (with air exhaust port facing downward).
 Install the bolt's head into the compressor housing's slot. Tighten the compressor firmly to the vehicle with the
provided lock washer and nut.
PAGE 1 of 2
VXA7223
INSTALLATION GUIDE