Advertisement
ENGLISH
Introduction
Congratulations on your purchase and welcome to Philips! To fully benefit from
the support that Philips offers, register your product at www.philips.com/
welcome.
Important
Read this important information carefully before you use the appliance and
save it for future reference.
Danger
-
Never immerse the appliance in water or any other liquid. Do not rinse
it with running water, except for the parts that can be removed and
rinsed according to the instructions.
-
Never use the appliance near flammable or toxic substances.
-
Do not vacuum up any liquid, flammable material or sharp objects,
such as needles or pins.
Warning
-
Check if the voltage indicated on the adapter corresponds to the local
mains voltage before you connect the appliance.
-
Do not use the appliance or the adapter if it is damaged.
-
If the adapter is damaged, always have it replaced with one of the
original type in order to avoid a hazard.
-
The adapter contains a transformer. Do not cut off the adapter to
replace it with another plug, as this causes a hazardous situation.
-
This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
-
Children should be supervised to ensure that they do not play with
the appliance.
-
Keep the appliance and its cord out of the reach of children.
-
To avoid danger of strangulation, keep the cord out of the reach of
children.
-
The plug must be removed from the socket-outlet before cleaning or
maintenance.
-
This appliance contains a UV emitter. Do not stare at the light source
and avoid contact with the skin.
-
To avoid eye injury, do not look into the UV light directly.
-
Do not point the UV light directly towards your own hands or body, the
hands or body of other people, or at pets during use.
-
Always return the appliance to a service centre authorised by Philips for
examination or repair. Do not attempt to repair the appliance yourself,
otherwise the guarantee becomes invalid.
-
Do not open the appliance and do not connect the appliance to the
mains when its housing is damaged or open.
Caution
-
Always switch off and unplug the appliance after use and before
removing the dust container or cleaning the appliance.
-
Do not use the adapter in or near a power outlet that contains an
electric air freshener to prevent damage to the adapter.
-
Do not use the appliance if you are highly sensitive to sunlight or bright light.
-
Never block the exhaust air openings or the vacuum inlet.
-
Always use the appliance with the dust compartment and the filter unit
assembled.
-
Always make sure that the washable parts of the appliance (i.e. the
outer filter and the dust container) are completely dry before you put
them back into the appliance.
-
Do not use a sharp object to clean the EPA filter, as this damages the filter.
-
Avoid placing your hands on or near the exhaust openings during use.
The exhaust air emitted by the appliance can be hot.
-
Do not touch the tapping feet when the tapping mode is active.
-
Do not use the appliance on hard floors or furniture in tapping mode.
-
Stop using the appliance when smoke, an unusual smell or an unusual
sound is coming out of the appliance. Unplug the appliance immediately
and contact the Philips Customer Care Centre.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and regulations
regarding exposure to electromagnetic fields.
Ordering accessories
To buy accessories or spare parts, visit www.shop.philips.com/service
or go to your Philips dealer. You can also contact the Philips Consumer Care
Centre in your country (see the worldwide guarantee leaflet for contact details).
Recycling
Do not throw away the product with the normal household waste at the
end of its life, but hand it in at an official collection point for recycling.
By doing this, you help to preserve the environment.
Guarantee and support
If you need information or support, please visit www.philips.com/
support or read the separate worldwide guarantee leaflet.
Troubleshooting
This chapter summarises the most common problems you could encounter
with the appliance. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Centre in your country.
Problem
Cause
The appliance
The rechargeable
does not
battery is empty.
work and the
battery icon
flashes red.
The
The filter unit or
appliance
the dust container
stops, the
with the filter unit
vacuum
are not assembled
icon flashes
or not assembled
and there is
properly.
an audible
warning
signal.
The suction
The dust container is
power
full, the filter is dirty
decreased
or if the vacuum
suddenly.
inlet is blocked.
The lamp is
If you use the
not always
appliance on a
on or goes
dark surface, the
on and off
response time of
from time to
the sensor is longer.
time.
The lamp goes on
and off as you move
the appliance over
different colours
and materials.
The appliance
The tapping feet do
stops, the
not work because
tapping icon
they are blocked by
flashes red
the fabric you are
and there is
cleaning.
an audible
warning
signal.
The motor that
drives the tapping
feet may be broken.
The appliance
The infrared sensors
stops, the UV
may be dirty.
icon flashes
red and there
is an audible
warning
signal.
The UV lamp may
be broken.
The
The dust container
appliance
is not assembled or
doesn't start
is not assembled
and the dust
properly.
container
icon flashes
red.
Solution
Recharge the appliance.
Make sure that you assemble the
filter unit in the dust container
and the dust container in the
appliance before you start using the
appliance.
Unplug the appliance. Empty the
dust container and clean the filter.
If the vacuum inlet is dirty, use the
brush to clean it.
The UV lamp is controlled by
a sensor in the bottom of the
appliance. This sensor ensures
that the lamp goes out when the
appliance is 5cm off the surface or
the surface is very dark.
The UV lamp is controlled by
a sensor in the bottom of the
appliance. This sensor ensures
that the lamp goes out when the
appliance is 5cm off the surface or
the surface is very dark.
Do not press the appliance into the
fabric too hard. Make sure you apply
light pressure so that the appliance
glides over the fabric easily.
Take the appliance to your dealer
or a Philips service centre. You can
also contact the Philips Consumer
Care Centre for information.
Clean the infrared sensors with the
cleaning brush.
Take the appliance to your dealer
or a Philips service centre. You can
also contact the Philips Consumer
Care Centre for information.
Push the dust container into the
appliance. When the dust container
is placed correctly, the dust
container icon stops flashing and
the appliance starts working.
Advertisement
