Table of Contents
Advertisement
Rotating the Antennas for Best Performance
This system broadcasts its high-quality audio and video using directional antennas.
The antennas can pivot and have limited rotation in either clockwise or counterclockwise
directions to obtain the best signal and picture clarity.
See the instructions shown below to rotate the antennas. Rotating the antennas
beyond the specified range will result in permanent damage to both antenna and the
mechanical stop. The antenna will not rotate 360 degrees.
Before you rotate the antenna, lift up the anten-
na first, and rotate the antenna clockwise/coun-
terclockwise no more than one full turn.
In most situations, the flat pitted face of the
antennas on both the camera and receiver should
be facing each other. Since all rooms are different,
additional adjusting of the antennas may be nec-
essary to get optimal performance. If the camera
and receiver are less than 10 feet apart, leave the
antennas in the closed (down) position.
The Auto-Sequence Feature
The Wireless Audio/Video Monitoring System can be set up to monitor a series of rooms
in a home or office. The receiver can connect up to three cameras on three different
channels for both Audio/Video reception, and display them in auto sequence. The system
has dip-switches for 3 channels to allow various monitoring options.
When the channel dip-switches are set in the "ON" posi-
tion, that channel is active on the receiver and can be
seen on the TV or monitor. Channel dip-switches in the
"OFF" position are inactive and will not be shown on the
TV or monitor.
The auto-sequence feature is activated when more than
one channel is switched ON. The channels switched ON
will display on the TV or monitor at three second intervals.
For example, if you have two cameras, one set to
Channel 1 and and the other set to channel 3 , the dip-
switch on the receiver must be set for both channels 1
and 3. Then camera one [CH1] and and camera two [CH3]
will start to display on TV/monitor in sequence at three
seconds intervals. This interval time is preset by the facto-
ry and cannot be adjusted by the user.
To stop the auto-sequence function:
Slide the dip-switch of the channel(s) you do not want
displayed to OFF on both that camera and the receiver.
Channels in the OFF position will no longer be displayed.
Rotate Clockwise/300º
Counterclockwise
Up/Down 84º
Channel Dip-Switch
Diagram Channel 1 ON
Channel Dip-Switch
Diagram, Channels
1 and 3 ON
5
Advertisement
Table of Contents
