Table of Contents
Advertisement
Installation
Installing Mounting Bracket (Camera Stand)
Tools you will need: • Pencil • Drill • Drill Bits • Phillips head screwdriver • Hammer
1. Select a mounting location. Use the mount-
ing bracket as a guide and mark the screw
holes with a pencil.
2. Drill 1/8" pilot holes over the center of each
pencil mark.
For mounting on drywall or sheetrock, use
the wall anchors provided. Gently tap the
anchors into the pilot holes with a hammer
until they are flush.
3. Align the bracket over the holes or wall anchors and tighten the screws to secure the
bracket to the wall or ceiling.
Installing and Aligning the Camera on the Mounting
Bracket (Camera Stand)
1. Remove camera platform and ball joint from the mounting bracket adjustment collar.
2. Secure the camera to the camera platform
on the adjustment collar. Hand tighten the
screw to the threaded insert located in the
base of the camera.
3. For battery operation, insert batteries as
detailed below.
4. Secure the camera, camera platform, and
ball joint to the mounting bracket until tight.
5. Adjust the camera. Rotate the ball joint
and/or collar slot while tightening to align the lens in the direction of preferred sight.
6. If the unit was shipped with a black lens cap, remove it.
Installing or Replacing Batteries
IMPORTANT!
When installing or replacing batteries:
1. Do not mix old and new batteries. Replace all the batteries at the same time.
2. Do not mix alkaline, standard and rechargeable batteries. Use one type of battery.
3. When storing the units or during long periods of non use, remove the batteries.
Failure to remove the batteries may damage the camera.
Installing Batteries in the Camera
The camera uses 4 "AA" size batteries to operate on battery power. Alkaline batteries
are recommended for longer operation.
To install/replace batteries:
1. Remove the battery cover by pushing the
lock of the area marked "OPEN".
2. Insert (or remove) the 4 "AA" size batteries.
NOTE: Install batteries using the polarity mark-
ings (+ and -) in the battery compartment.
Attach Stand to Mounting Surface
Attach Stand
to Camera
3
Advertisement
Table of Contents
