R.G.V. UP&DOWN Instruction Manual page 10

EN
• Before connecting the appliance, make sure that the data on the plate correspond to those
of the electricity distribution network. The plate is located under the motor body.
• For your safety, it is recommended to supply power through a differential switch (RCD) with
a tripping current not exceeding 30 mA.
• In case of incompatibility between the socket and power cable plug, have the socket re-
placed with a suitable type by a qualified professional who will also have to make sure that
the section of the cord is suitable for the power absorbed by the appliance.
• We do not recommend the use of adapters, multiple sockets and / or extensions.
In case their use should become essential, it is necessary to only use simple or multiple
adapters and extensions compliant with the safety standards in force, taking care not to
exceed the capacity limit, in terms of current, marked on the simple adapter and on the
extensions, and the maximum power one marked on the multiple adapter.
• The use of an electrical appliance requires the observance of some fundamental rules. In
particular:
- do not touch or use the appliance with wet or damp hands;
- do not use the appliance barefooted;
- do not pull the power cord or the appliance itself to remove the plug from the socket;
- do not leave the appliance exposed to atmospheric agents (rain, sun, etc.);
- do not allow the appliance to be used by children or unskilled persons without super-
vision.
• In case of failure and/ or malfunction, turn it off and do not tamper with it. For possible repair,
only refer to a technical assistance centre authorized by the manufacturer and request the
use of original components and spare parts.
Failure to comply with the above may compromise the safety of the appliance.
• If you decide not to use this appliance again, it is advised to make it inoperative by cutting
the cord after removing the plug from the socket.
It is also recommended to make harmless those parts which may constitute a danger, espe-
cially for children who could use an abandoned appliance as a toy.
• Installation must be carried out according to the instructions of the manufacturer. A wrong
installation may cause injury the persons, animals or damages to property for which the
manufacturer cannot be held liable.
• To avoid dangerous overheating, it is recommended to uncoil the power cord along its entire
length and use the appliance as recommended in the "OPERATION" paragraph.
• To avoid overheating, do not operate the machine continuously for more than 20 seconds. If
the appliance is to be used in succession, alternate cycles with pauses of at least 20 seconds.
• Do not leave the appliance switched on unnecessarily. Disconnect the mains plug from the
power supply when the appliance is not in use.
• Do not obstruct the ventilation or heat disposal openings or slots.
• If the power cord of this appliance is damaged, it must only be replaced by a service centre
authorised by the manufacturer, as special tools are required.
10