IHP GAB Series Quick Start Manual

GAB AND GAP SERIES EXTRUDED LOUVER KITS
[FOR USE WITH MODELS VCM3026 AND GAMMA26]
KIT CONTENTS
2 ea. Louvers
1 ea. Instruction Sheet
Check to see that new louvers in your kit are the same length as
old louvers on your heater and the desired color. If not, return kit to
dealer and exchange for the correct kit.
Cat. No. Model
F1818 GAB9092 26" Extruded Louvers, Black
F1819 GAP9092 26" Extruded Louvers, Platinum
f i r e - p a r t s . c o m
REQUIRED TOOLS AND SUPPLIES
Phillips Screwdriver
GENERAL INFORMATION
Extruded louvers are available in black or platinum fi nishes.
READ ALL THE STEPS BEFORE STARTING THE INSTALLATION
THE FIREPLACE MUST BE OFF AND COLD BEFORE BEGINNING.
ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN THE
INSTALLATION AND OPERATION MANUAL PROVIDED WITH THE
APPLIANCE APPLY TO THESE INSTRUCTIONS.
If you encounter any problems, need clarifi cation of these instructions
or are not qualifi ed to properly install this kit, contact you local
distributor or dealer.
If any of these parts are missing or damaged, contact your dealer or
IHP.us.com for referral information.
INSTALLATION INSTRUCTIONS
Top Louver
1. Remove four screws from top louver using a Phillips screw-
driver (see Figure 1).
2. With rungs pointing down, install new louver using 4 screws
removed in step one. Tighten all screws securely.
Bottom Louver
1. Lower bottom louver door.
2. There are two screws on each end of louver door that hold
hinges in place. Remove two screws from right end of louver
door only (see Figure 2). The louver door should easily pull
free of cabinet. Do not remove second hinge or screws at this
time.
IMPORTANT: Hinges are not interchangeable. The left hinge
must stay on the left side and right hinge must stay on the right
side.
P/N 111544-01
Rev. C, 04/2017
Description
IHP.us.com
NOTE: Screws are numbered by order of installation. See Figure 4.
3. Attach hinge to right end of new louver beginning with screw
#1 (see Figure 4). Start screw #2 into hinge, then tighten both
screws.
Figure 1 - Removing Top Louver
1. Insert hinge already secured to new louver into hinge installa-
tion hole on right side of cabinet where originally positioned.
See Figure 3.
2. Remove second hinge from old louver.
3. Insert second hinge into hinge installation hole on left side of
cabinet where originally positioned. Start screw #3 into louver
and hole on hinge (see Figure 4, Page 2). Insert screw #4 then
tighten both screws.
4. Close louver door.
Screws
Bottom
Louver
Figure 2 - Removing Screws
from Hinge
HEARTH PRODUCTS
KITS AND ACCESSORIES
26" EXTRUDED LOUVER KITS
Top Louver
Screws
Hinge
Installation
Right Hole
Hinge
Screw
Hole #2
Screw
Hole #1
Figure 3 - Left and Right
Hinges
1