SSV Works US2-C8 Quick Start Manual

SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com | Phone: 818-991-1778 | Fax: 866-293-6751
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or
workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects
in material or workmanship. Labor for replacement of defective components is not covered. All
SSV Works Speakers are covered by a limited 1 year warranty against defects in material or
workmanship. Contact SSV Works for further warranty information.
TOOLS NEEDED FOR INSTALLATION
- 5mm Allen Key
- 3mm Allen Key
PARTS LIST IMAGES
1. US2-C8 Enclosures (1 pair)
4. M6x1.0x20mm (8mm Hex
Head) Screws & Washers x4
INSTALLATION NOTES
It is recommended to wrap the
bag that the clamps come in
around the cage before you
slide the clamp onto the cage to
prevent scratching.
- 8mm Open End Wrench
- #2 Phillips Screwdriver
2. Dual Mounting Ring
Adapter x 2
5. M6x1.0x45mm (5mm Allen
Head) Screws & Washers x4
Figure 1
SSV Works 8" Speaker Enclosures
!
Placement of the pod depends on what type of roll
cage you have (factory or aftermarket) and your
preference of where you want the pods to be installed.
In these instructions, we have installed them on the
outside vertical bars at the back of the roll cage.
3. Ring Clamp x 4
6. M6x1.0x6mm (3mm Allen
Head) Screws x4
FOR UNLOADED ENCLOSURES:
If using an alternative brand speaker, first see if
the speaker holes line up with the screw bosses
(circled in pink on Figure 1). Use the supplied (8)
SSV Works #7 screws when installing your own
speaker.
US2-C8
Universal Cage Mount
Please read and understand these
instructions completely before
installation to avoid possible injury, or
damage to the accessory or vehicle.
7. #7 Screws x 8
(comes with unloaded pods only)