Test The Vcr (Record/Stop) (Sat-A65A Only) - Sony SAS-B65D Service Manual

Test the VCR
(Record/Stop)
(SAT-A65A only)
Signals coming from the remote
control at the same time as
signals coming from the VCR
Control cable may provide
unreliable test results.
7. Test the VCR control feature as described below.
8. Remove the temporary mounting tape. Attach the emitter permanently with
peel-and-stick backing. This will not interfere with normal VCR operation.
The VCR SETUP menu provides the settings to allow the DIRECTV
Receiver to communicate with your VCR.
VCR SETUP
Install
Signal
VCR
Prefs
Test
New Card
Upgrade
Features
Exit
Return
9. Scroll through the VCR brands using the navgation buttons. If you cannot
find the correct code listed for your brand of VCR, try related brands that
use the same code. Your VCR may also respond to multiple codes.
10. Use the remote control
11. Alternate between this procedure and testing the code.
This Record/Stop test verifies the specified brand and code controls your VCR.
Before starting the test:
• Turn the VCR power on.
• Verify the VCR Control Cable is properly connected.
• Insert a recordable videotape into the VCR.
Use the DIRECTV Receiver front panel controls, rather than the remote control,
to test the codes.
Test the VCR record and stop commands. If either command does not function,
try other codes shown for your VCR brand. If you are unsuccessful after trying
all available codes, recheck your VCR Control Cable connections and IR
emitter placement.
Brand Code
Admiral 1
Aiwal
2
Akai
3
Audio Dynamics
4
Bell & Howell 5
Brooksonic
Canon
Select a code
SELECT button to try each code.
Adding system components
®
Thu, Aug 2 2:22 PM
Test
Record
Stop
Clear
9