Do you have a question about the KIRA-DUAL9022BL and is the answer not in the manual?
Questions and answers
Dan Langfeld
February 9, 2025
I have two pipes from wall hat and cold . The shower tower only has one hose to connect to water
1 comments:
Mr. Anderson
May 14, 2025
The Akuaplus KIRA-DUAL9022BL shower tower connects to your existing water installation. Place the shower column against the wall at the desired height, ensuring that the water supply fittings (hot and cold) align properly and are not blocked by any part of the column. The water supply fittings should extend 3/4 inch (2 cm) beyond the final wall covering. Always leave an opening at the back of the column to access the connections for maintenance or repair. It is recommended to hire a professional plumber for the installation.
Page 1
INSTRUCTION MANUAL•MANUEL D’INSTRUCTION KIRA-DUAL9022BL Shower System•Système de douche Store/Magasin 1 844 666-0155 SANS MITIGEUR Se connecte à votre installation déjà existante. WITHOUT MITIGATOR Connects to your existing installation. DO NOT RETURN THIS PRODUCT TO STORE, CONTACT US. We’re there if you need help.
Page 2
We recommend that you hire a professional plumber to install and repair this product. Refer to the regulations stipulated in the Plumbing Code and inquire about your municipality’s requirements before proceeding to the installation. The Plumbing Code requires the installation of a water-hammer arrestor. ALLOW PROPER OPENING FOR EASY ACCESS TO CONNECTIONS OR OTHER PLUMBING DEVICES FOR MAINTENANCE OR REPAIR.
Page 3
74mm 1 Shower panel Colonne de douche 11 90° brass connector Raccord 90° en laiton 2 Shower arm Bras de douche 12 Hand shower holder Support à douchette 3 Rubber washer Rondelle d’étanchéité 13 Faucet supply tube Tube d’alimentation 4 Shower head kit Ensemble de la pomme de douche 14 Brass connector 1 7/8 - 1/2 in.
340mm 200mm 17mm 254mm 10” Recommended Recommandé 70mm 120mm Technical data Données techniques Maximum operating pressure ............125psi Pression de fonctionnement maximale .......... 125psi Recommended pressure ............50~80psi Pression recommandée ............50~80psi Test pressure: ..............20psi, 125psi Pression d’essai ..............20psi, 125psi Recommended hot water temperature ..........
Page 5
Place the shower column against the wall at the desired height in order to mark the position of the wall bracket (B), you will have to adjust yourself so that your water supply (A) is not hampered by an element of the column, the fitting of the water supply should come out of your final 3/4 ‘’...
Page 6
WARNING/ AVERTISSEMENT Before connecting to your water supply, flush your piping to make sure it is free of sediment, flux, weld residue, deposits, debris or any other impurities that could damage your new faucet. Failure to rid your piping of the contaminants mentioned above will void your warranty and may result in premature failure, as well as property damage.
Page 7
Impurity filter washer. Rondelle d’étanchéité avec filtre à impureté. Put on the impurity filter washer (D). Apply teflon (E) tape on thread. Screwing in firmly by hand and tighten with ¼ turn with an adjustable wrench. Connect the hose to the shower panel while making sucertainhey are not twisted.
Any warranty bxecomes void if the product was used in a non-recommended way or has been est invalide si le produit a été utilisé de façon non recommandée ou s’il a fait l’objet de négligence. akuaplus® n’est abused.
Need help?
Do you have a question about the KIRA-DUAL9022BL and is the answer not in the manual?
Questions and answers
I have two pipes from wall hat and cold . The shower tower only has one hose to connect to water
The Akuaplus KIRA-DUAL9022BL shower tower connects to your existing water installation. Place the shower column against the wall at the desired height, ensuring that the water supply fittings (hot and cold) align properly and are not blocked by any part of the column. The water supply fittings should extend 3/4 inch (2 cm) beyond the final wall covering. Always leave an opening at the back of the column to access the connections for maintenance or repair. It is recommended to hire a professional plumber for the installation.
This answer is automatically generated