Advertisement
Installing the Bracket and Sensor Node
1
Orient the bracket so the text TOP is facing
upwards.
2
To install the bracket onto a wall, use
the two long screws included in the
package. Screw the bracket to a wall
using the two holes on the mid-section
of the bracket.
3
To install the bracket
onto a pole, slip a cable
tie through each of the
channels on the bracket
and fasten the tie
around the pole.
1-800-LOGGERS
4
Insert the bottom of the
sensor node into the retaining
clips on the bottom of the
bracket then press the top of
the sensor node into the clips
at the top of the bracket.
5
Use the short screw
included in the package to
fasten the sensor node to
the bracket.
Close the sensor node and use a padlock to keep it secure.
6
Note: Ensure that the node seal is clean from foreign
debris.
2
www.onsetcomp.com
Advertisement
