Programming Instructions; Water Temperature Control; Switching To Cooling Operation; Cooling Device Control - Dupla MultiControl Directions For Use Manual

5. Programming Instructions

First tap "Menu" key to start the programming mode.
Hint: The symbol "Menu" indicates you are in the programming mode. By holding down "Menu" it is possible
to quit the programming mode at any time.
5.1 Control of Water Temperature
When pressing the "Menu" key, "25.0" flashes on the display.
Set the required value with the ▲ or ▼ key.
Acknowledge with "Menu" key, "0" will flash.
Set the required value with the ▲ or ▼ key.
Acknowledge with the "Menu" key to return to the main menu.
Scroll through to the next menu item with the ▲ key.
5.2 Switch to Cooling Operation
If the alternate cooling operation is not desired, scroll directly to the next menu item by pressing the ▲ key.
Otherwise press the "Menu" key -"HEAT" flashes.
Change to "COOL" with the ▲ key
Acknowledge with "Menu" to return to the main menu.
Scroll through to the next menu item with the ▲ key.
5.3 Control of a Cooling Device
Press the "Menu" key, "3.0" flashes
Set the required value with the ▲ or ▼ key.
Acknowledge with the "Menu" key to return to the main menu.
Scroll through to the next menu item 10 with the ▲ key.