Table of Contents
Advertisement
Information on the display panel
Display
The door cannot be
locked, please open
the door again, then
close it and select
"start/pause".
Please open tap
Please clean pump
Pause: Reload is not
possible
Door cannot be
unlocked: Water
level or temperature
is too high
aquaStop has been
activated!
Please call customer
service
Auto power-off in ...
seconds,
Cooling down the
detergent solution
Other displays
Error E: XXX
Cause/Remedy
– Washing may be caught. Please open and close washing
machine door again and select Start/Reload
– If required, shut washing machine door or remove washing and
shut again.
– If required, switch appliance off and on again; set programme
and make individual settings; start programme.
– Turn on tap fully.
– Supply hose kinked/jammed.
– Water pressure too low. Clean the filter. ~ Page 37
– Drain pump blocked. Clean the drain pump. ~ Page 35
– The water drainage pipe/drain hose is blocked. Clean the
drainage hose on the siphon. ~ Page 36
Water level or temperature is too high.
Select Start/Reload
Water level or temperature is too high.
Select Start/Reload
not applicable without Aqua-Stop
Water in the base pan, appliance leaking.
Call customer service! ~ Page 42
Appliance automatically switches off after ... seconds if it is not
operated for a prolonged period. In order to cancel the programme,
press any button. ~ Page 32
To protect the wastewater pipes, the hot detergent solution is
cooled before being drained.
Switch off appliance, wait 5 seconds and switch on again. If the
display is indicated again, call customer service. ~ Page 42
Ü
to continue the programme.
Ü
to continue the programme.
Ü
.
39
Advertisement
Table of Contents
