Table of Contents
Advertisement
CD-ROM Drive
The CD-ROM drive enables you to read CDs. The drive is operated as a slave
parallel to the hard disk drive via the secondary IDE interface.
Opening the
Swing the PG 720 into a horizontal position. The CD-ROM drive is now on
Drawer
the underside of the programming device. By briefly pressing the eject
button, the drawer springs out slightly. Now pull the drawer out until it clicks
into position.
Inserting /
When you first open the CD-ROM drive, you will find a transparent film
Removing CDs
sheet in the drawer, to protect the drive during transport. Remove this film
and retain it in case you need to transport your device again. Now insert the
CD in the drawer with the labeling face up, and press it firmly down into the
center of the turntable. To remove the CD, hold it by the edges and pull
upwards.
Closing the Drawer
Push in the drawer until it closes completely. Do not press the eject button.
Note
To avoid too much pressure on the open drawer, always hold the drawer at
the front with one hand when inserting or removing a CD.
The CD-ROM has a mechanical release. The EJECT function offered by
various applications for opening the CD-ROM drawer does not work with
this drive.
CD-ROM Front
Caution
!
Risk of data loss and damage to the drive!
CD-ROM drives are sensitive to vibrations and shock. Any vibrations occuring
during operation can lead to damage to the drive or CD.
Drive Types
The PG 720 is equipped with one floppy disk drive and one hard disk drive as
standard.
PG 720 P Product Information Bulletin
C79000-K7076-C721-01
On/Busy
1
2
1 Access display
2 Drawer
3 Eject button
3
9
Advertisement
Table of Contents
