Table of Contents
Advertisement
Parts Needed
(not included in the kit)
Aileron extension (2) (JRPA101, 18", Gold)
Y harness (1)(JRPA133) (Needed to connect aileron servos to one channel (Aileron) of the receiver)
Propeller (Refer to propeller recommendations listed in your engine's operating instructions)
Foam for cushioning tank
Fuel tubing (12")(Gas or glow, depending on your choice of engine)
Fuel filler
Shut-off switch for gasoline engine operation (ZEN20000)
Note: This is an important safety item for all gasoline powered engine installations.
Tools and Supplies Needed
(not included in kit)
Adhesives
Thin CA (cyanoacrylate) glue
Thick CA (cyanoacrylate) glue
CA remover/debonder
6-minute Epoxy
30-minute Epoxy
Blue Locktite
®
Canopy glue
Tools
Drill
Drill bits; 1/16", 1/8", 5/32", 1/4", 3/8"
Medium Phillips screwdriver
Z-bend pliers
Pliers (needle nose)
Small round file
Hobby knife with #11 blade
Mixing sticks
Epoxy brushes
90-degree triangle
Medium sandpaper
Masking tape
Straight edge
Measuring device (e.g., ruler, tape measure)
Scissors
Paper towels
Wax paper
Rubbing alcohol
Felt-tipped pen/pencil
T-pins
Moto-tool with cut-off wheel
Other Equipment Items
Radio packing foam
Antenna tube
Scale detail supplies per Greg Hahn included in instructions
5
Advertisement
Table of Contents
