Table of Contents
Advertisement
Enabled - Robot set Watch Dog Timer (WDT) after POST completion, before BIOS
transfer control to OS. WARNING: Before enabling this function, a program in OS must
be in responsible for clearing WDT. Also, this function should be disabled if OS is going
to update itself.
OS Timer (minute)
Timer count set to Watch Dog Timer for OS loading.
Delayed POST (PEI
phase)
Enabled - Robot holds BIOS from starting POST, right after power on. This allows BIOS
POST to start with stable power or start after system is physically warmed-up. Note:
Robot does this before 'Sends watch dog'.
Delayed time
(second)
Period of time for Robot to hold BIOS from POST.
Delayed POST (DXE
phase)
Enabled - Robot holds BIOS before POST completion. This allows BIOS POST to start
with stable power or start after system is physically warmed-up. Note: Robot does this
after 'Sends watch dog before BIOS POST'
Delayed time
(second)
Period of time for Robot to hold BIOS from POST.
Reset system once
Enabled - Robot resets system for one time on each boot. This will send a soft or hard
reset to onboard devices, thus puts devices to more stable state.
Soft or hard reset
Select reset type robot should send on each boot.
Chapter 3 – AMI BIOS Setup
3
Disabled
Enabled
10
Disabled
Enabled
10
Disabled
Enabled
Soft reset
Hard reset
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
Optimal Default, Failsafe Default
58
Advertisement
Table of Contents
