Kyocera Mita FS-1800N+ User Manual page 13

Make sure that the paper tray is lowered and stopped. Then,
3.
while watching the side plates inside the feeder, rotate the
paper adjuster knob on top of the feeder clockwise. Stop
rotating the knob when the side plates have been set to their
widest settings (outmost positions). See figure below.
Place several sheets of the paper you are going to use with the
4.
feeder on the center of the paper tray.
Inside Panel
Side Plates
Adjust the side plates by rotating the adjuster knob on top of
5.
the feeder counterclockwise so that the left and right side edges
of the paper are flush with the left and right side plates.
Then, rotate the adjuster knob half a turn clockwise. This
allows an approximately 1 mm gap between each side of the
paper stack and the side plate, which is needed to ensure the
proper paper feeding. See figure below.
pf8-Eng.pm6
Tray
Paper
Make sure that the paper edges are evenly
aligned on the center of the tray and the front
edge of the stack fully abuts on the feeder's
inside panel
11
Adjuster Knob
Cover
12/19/00, 8:22 PM
11