Removing Condenser; Removing Propeller Fan; Removing Fan Motor - Sanyo SA-123AH Technical & Service Manual

Table of Contents

9-6. Removing Condenser

(1) Remove splasher plate A fixed to the

condenser.

(2) Remove other screws holding the

condenser.

(3) Grasp lower portion of the condenser with

both hands and tilt it slightly and lift it

carefully from the base pan so as not to

distort the copper tube.

(1) Remove the condenser.

Refer to "9-6. Removing Condenser"

(2) Loosen a nut holding propeller fan on motor shaft using

hex. wrench. (Fig. 13)

NOTE

To loose the nut securing the propeller fan, hold the fan with

one hand and turn the nut COUNTERCLOCKWISE with

another hand.

(3) Extract the propeller fan from the motor shaft.

(1) Remove blower wheel.

Refer to "9-5. Removing Blower Wheel"

(2) Remove propeller fan.

Refer to "9-7. Removing Propeller Fan"

(3) Disconnect motor lead wires.

Refer to "9-2. Removing Electrical Component Box"

(4) Remove 4 screws of the fan motor mounting plate with a

philip screwdriver. (Fig. 14)

(5) Disengage the fan motor from the mounting plate.

(Fig. 12)

Fig. 12

Fig. 13

Fig. 14

Table of Contents