Sending Or Receiving Data; Data And Voice Transmissions; Setting Up A Data Connection; Receiving Data Or Fax Calls - Kyocera QCP 1960 User Manual

Sending or Receiving Data

Some service providers allow you to connect your phone to your computer and use the
phone line for email, Internet access, or fax transmission.
Digital mode: To receive data in CDMA digital mode, you can connect your phone to
a computer using a Kyocera Wireless Corp. data cable (available separately). See
"Setting up a data connection" on page 29.
Analog mode: To receive data in analog mode, you can purchase the Kyocera
Wireless Corp. Data on the Go
To purchase these accessories, contact your service provider or visit the Kyocera Wireless
Corp. web site at
http:\\kyocera-wireless.com/store

Data and voice transmissions

Before using your phone to send or receive data, be aware of the following
considerations.
Due to infrastructure (network) limitations, there may be times when your phone cannot
determine if an incoming CDMA digital call contains voice or data/fax information.
Check with your service provider to see if both voice and data/fax signals are
supported. If the network cannot distinguish between voice and data/fax calls, and you
are expecting a data call, you can set the phone to data mode.
Important—When the phone is in data mode, you cannot receive incoming voice calls.

Setting up a data connection

Follow these steps to set up a CDMA data connection.
With your phone turned off, plug the flat connector on one end of the data cable into
1.
the port on the bottom of the phone.
Plug the serial connector on the other end of the data cable into the serial port on
2.
your computer.
Turn on your computer.
3.
Press or to turn on the phone.
4.
pwr
Open a communications software package on your computer.
5.
To send or receive faxes and email or to access the Internet, follow the directions that
6.
came with the communications software.

Receiving data or fax calls

If you are expecting a data or fax call, follow these steps to put your phone in data mode.
Press or
1.
Press 8 4 to select System>Data/Fax.
2.
Press or
3.
User's Guide for QCP 860, QCP 1960, and QCP 2760 Thin Phones
PC Fax/Modem Card to install in your computer.
®
under [MENU].
under [NEXT] to cycle through the settings.
29