Installation; Wiring Instructions - Ecco EW2011B Installation And Operation Instruction Manual

Installation

For best results, select a mounting location between approximately
72" to 144"[1828 mm to 3658 mm] from the ground. Once mounted,
angle the lighthead so the pedestrian light appears in the desired
location as shown in FIGURE 1.
1. Select a mounting location for the unit on a flat surface, and drill
a 5/16" hole.
2. Secure the light head with the supplied hardware.
3. Loosen screws located on each side of the worklamp to adjust
the lighthead to face downward as shown. Tighten the screws to
hold in desired position.

Wiring Instructions

Black Wire: Connect to (-) ground
Red Wire: Connect to a dedicated (+) power source with a customer
supplied inline fuse.
See wiring diagram in Figure 2 for details.
35° max.
Figure 1
LENS
VEHICLE
MOUNTING POSITION
BODY
IMAGE FOR REFERENCE ONLY
Figure 2
72" to 144"
[1828mm to 3658mm]
RED BLACK
GROUND
(-)
(+)
GROUND
Page 2 of 3