Table of Contents
Advertisement
System 3000
RF operating top unit
7
Information for electrically skilled persons
7.1 Fitting and electrical connection
DANGER!
Mortal danger of electric shock.
Disconnect the device. Cover up live parts.
Mounting and connecting the device
In secure operation (preconditions):
–
Secure commissioning is activated in the ETS.
–
Device certificate entered/scanned or added to the ETS project. A high resolution camera
should be used to scan the QR code.
–
Document all passwords and keep them safe.
The insert must be disconnected from the power supply before plugging in or unplugging
the RF operating top unit.
Switching, dimming, Venetian blind or room temperature controller insert or 3-wire extension are
mounted and connected properly (see instructions of the relevant inserts).
The mains voltage has been switched off.
￭
Fit the cover with frame on the insert (Figure 1).
￭
Switch on mains voltage.
￭
In secure operation: The device certificate must be removed from the device and stored
securely.
The device can be commissioned and is ready for operation.
If the status LED flashes red three times at repeated intervals, the cover was previously
connected to another insert. To enable operation again, either place the cover on the as-
sociated insert or put the device combination into operation with the ETS.
When switching to another application, the device should always be reset to the default
setting and then reprogrammed.
32403802
10867449
10.11.2021
8 / 12
Advertisement
Table of Contents
