Adjusting The Volume - Monacor TRAVEL-VLOG Instruction Manual

After use or during longer periods of inactivity, switch
off the devices to prevent unnecessary discharge of the bat-
teries . To do this, keep the button
3 seconds until the LEDs go out . The receiver switches off
automatically after 5 minutes if it has not received any radio
signal from the transmitter .
6.2 Changing the channel
If there is interference during transmission (e . g . from other
wireless transmission systems), the transmission channel can
be changed with the buttons +/− (9) on the transmitter . The
receiver will automatically change the channel accordingly .
6.3 Muting the sound
To mute the sound, briefly press the button
receiver . To indicate muting, the LED PAIR (2) flashes briefly
only every 2 seconds . To unmute the sound, briefly press
the button again .

6.4 Adjusting the volume

Average volume is preset each time the device is switched on .
The buttons +/− (9) on the receiver can be used to increase
or decrease the volume as desired .
7 Fastening Options
The clips (7) on the back of the transmitter and the receiver
offer versatile fastening options, e . g . on your clothes . In
addition, the clip is dimensioned to fit into the standard hot
shoe of a camera .
The tie clip microphone has its own clip . In case of strong
wind noise, the foam windshield can be replaced by the
artificial fur windshield provided .
(5) pressed for approx .
14
(5) on the