Overview Of The Unit; Disassembling The Unit - Immergas MAGIS M4-30 Use And Installation

NOTE
• The volume of the balance tank (8) should be greater than 40 L. The drain valve (6) should be installed in the lowest
position of the system.
• The junctions of the water inlet and outlet pipes of each unit of the parallel system should be connected with soft fit-
tings, and the one-way valves must be installed on the water outlet pipe.
• The temperature sensor Tbt1 must be installed in the parallel system (otherwise the unit cannot be started), the tem-
perature point is set in the balance tank (8).
9

OVERVIEW OF THE UNIT.

9.1 DISASSEMBLING THE UNIT.

Models 4-16 kW.
Door 1 To access the compressor, the electric
parts and the hydraulic compartment
4/6kW
WARNING
• Before removing doors 1 and 2, disconnect power to the unit and the domestic hot water storage tank (if applicable).
• The components inside the unit could be hot.
Models 18-30 kW.
WARNING
• Before removing door 1, switch off all the supplies of the unit.
• The components inside the unit could be hot.
Door 1
Door 2
1
Door 1 To access the compressor, the electric
Porta 1 Per accedere al compressore e alle
parts and the hydraulic compartment
parti elettriche e al comparto idraulico
49
To access the compressor and the electric
components
To access the hydraulic compartment and the
electric components
8/10/12/14/16kW
1
1 2