If there is strong wind and its direction can be foreseen, refer to the figures below for installation of the unit (any of them
will do).
Turn the outlet side of the air towards the wall of the building, fence or screen.
Make sure there is sufficient space for installation.
Arrange the outlet side at a right angle with respect to the wind direction.
• Prepare a water discharge channel around the foundation, to drain the water around the unit.
• If the water has difficulty flowing out of the unit, mount the unit on a cement block foundation, etc. (approximately 100
mm (3.93 in) high).
• If the unit is installed on a frame, assemble a waterproof plate (about 100 mm) on the lower side of the unit to prevent
the water from entering from below.
• When the unit is installed in a place frequently exposed to snow, please pay particular attention to raise the foundation
as high as possible.
Under normal conditions, refer to the following figures for installation of the units 18-30 kW:
Unit
4-6 kW
8-16 kW
19
B
≥ 1000 mm
≥ 1500 mm